My aging K3, S/N 298, is once again proving a little troublesome. Into a
nice solid 50 ohm dummy load with a strong 14 volt supply and short
thick cables never known to be an issue I see a maximum of about 10
watts out when set to 110 watts on the front panel. Starting at 0w it
increases in line with the setting until about 3.5 watts. The LPA stops
there and then when the KPA3 comes in it goes up to about 10 watts but
beyond that no further increase.
I presume this is a either a drive or and LPA issue but I suspect the
actual cause might be well known here. What are the chances?
Regards
Martin, HS0ZED
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
