Hi all, I am trying to do the RF Calibration test using my new XG3. I am getting the error below. I have all firmware up to date on the K3s and the XG3. I even tried reloading the firmware on the K3s just to see if that worked. Of course turning it off and back on again did nothing either. I DO have the SUB RX on this rig as well, ideas?
TIA and 73, K5RHD /Randy Elecraft K3 Utility for OS X Revision 1.18.6.28 OS X Version 10.15.4 K3 MCU revision 05.67. RS-232 speed 38400 bps. Turning sub receiver off Unlinking VFOs Selecting Antenna 1 Setting mode to CW Turning squelch off Turning Preamplifier off Turning Attenuator off Setting Filter Width to 100 Hertz Setting RF Gain to maximum Turning CW Tune on Writing factory default calibration data Writing calibration table to DSP Delay 100 ms K3 did not respond to DSP command !bc20007401350137023802390139033C033A023C033B033D043E053E063D063C083F093C0C3C0D3E0E3D103F0F3C0F400E3F0F3F103E143F1A401F41223F273F2D41333F3E404A4150403B3F113E0244013E003F0041003F003F0140004000400141033D064313412041243F18400B410742033C0442014100EE007451236D5338; Power cycle K3 and try calibration again. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com