Al,
The C22 setting does nothing to change the K2 display - you must run CAL
PLL and CAL FIL (for all filters) before any change in the display takes
place. Normally, the reference oscillator only serves as a clock for
the MCU - the frequency display does not depend on it.
See the K2 Dial Calibration on my website www.w3fpr.com.
If you are using RWM (which transmits only a carrier), you should use
the method EA3ADV and I developed to use only a carrier instead of the
transmitted tones such as those from WWV.
73,
Don W3FPR
On 6/5/2020 4:59 AM, W4RAM wrote:
Good morning,
I am looking for assistance to be able to properly complete the reference
oscillator calibration.
Situation: despite moving C22 I don't see any change or correction when I
try to zero beat signal from RWM (9,996.00)
Performed procedure:
1. I tuned the K2 with the RWM signal. I was able to "zero beat" in 9,998.25
LSB (diff. +2.25).
2. I connected the internal counter from P6 to TP1.
3. I adjusted C22 (moved counterclockwise)
I did not continue with Run CAL PLL and CAL FIL.
I am using vertical HF external antenna.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
