If you do a google search on KX1 zero beat indicator or cw zero beat indicator
you will see several circuits demonstrated. Some like the one which uses the
LM567 (non SMT) part and had
a white LED seemed to be good, much less than 100 Hz BW and had the schematic,
but some others seemed to be much too broad, perhaps hundreds of Hz wide. My
circuit
needed quite a bit of audio drive, so rigged up a small 500-500 CT audio
transformer and used the primary as a autotransformer to double the audio
voltage
to the circuit which did not change the earphone volume but enabled the
detector to operate without opening up the audio gain too much on any of my
rigs.
Good Luck Rick KL7CW
Sent from Mail for Windows 10
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
