Wake On LAN is not functioning on my KPA-1500 using the remote software. I have the Wake On Lan and DHCP boxes checked in the Network tab in the configuration settings within the KPA1500 Utility program, and the LAN settings (including the IP address) are correct.
The only condition in which the remote software (v1.27) can find the KPA1500 is when the amp is manually powered on, after which it operates fine. Once I power down the amp there is no condition in which I can reattach the software remotely-I must power the amp on from the front panel button. In addition to this, just pressing the "connect" button won't do it either. I have to press the TEST button, wait until it finds the amp, then press CONNECT and it connects normally. At the moment this isn't a deal breaker, but I intend to remote the amp next week to a relatively inaccessible space in the basement so I'd like to get this solved as soon as possible. As a side issue, the DHCP IP address had changed at some point, and the remote software did NOT pick up the change. I had to hunt in my router for the MAC address and enter the new IPV4 address manually into the remote software. --------------------------------------------- Please and thanks. Peter, W2IRT ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
