Hello all,
I have two Elecraft transverters One I put together in about 2009 it is a
144Mhz. after building and going through the alignment procedures I could not
get it to work properly. I got side tracked and set it aside and have not
messed with it since. A month or so ago I pulled out the other one which is a
50Mhz transverter. Both of these were purchased by my father in law. He started
the build on the 50 Mhz unit then at some point his key fell silent. So when we
clean out the house I packed all we could find of it in a box. And a month or
so ago I went to finish it. And was surprised to find I was only short by one
resistor. But in trying to get all my Elecraft manuals in one place I found an
Errata for Xv transverters dated may, 11 2011 Rev. D-3. The main change there
is L19 The older Errata states to delete the step to remove the tuning slug in
L19. And the later one Rev. D-3 states page 17, Parts Inventory, XV144: Add the
following new part at the bottom of the page. L19
1 each 198 nH, 7MM, RF Inductor, Violet E690226. My question is this for both
144 and 50 Mhz transverters or just the 144 Mhz units. The reason I ask is
neither one has the tuning slug in that location nor does it appear there ever
was one. And the manuals are for the 50, 144, and the 222 Mhz units with just a
few differences. At the end there is a small section that has you in stall the
proper parts for the specific unit you are assembling.
Joe AB3JN
Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 1
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
