On 6/18/2020 8:30 PM, [email protected] wrote:
How do I get my K3 Tx audio to have more “punch”.
Set TXEQ as follows: Three lowest bands max cut (-18 dB), fourth band -6 dB, two highest bands +3 dB. Turn COMP all the way down, then set Mic Gain per the manual. NOW, turn up COMP, set the display meter to read Comp, and while to talk like you would on the air, increase COMP until you see about 10 dB of COMP on the meter on voice peaks.
Now get some signal reports from "good" listeners. Tell them to listen with their widest IF filter setting. Tell them you DON'T want "warmth" or "fullness," you want a signal that will cut through QRM an noise, but still sound pleasant. Depending on your mic and your voice, you may want to use more or less cut of the 4th band, and a little more boost of the top two. Don't go higher than 6 dB.
73, Jim K9YC ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
