There is artifact(s) that appear on PX3 but they are really low strength and will disappear as you see real signals.
Sent from my iPhone ...nr4c. bill > On Jun 20, 2020, at 9:29 AM, Robin via Elecraft <[email protected]> > wrote: > > I have tried this with two KX3’s with the same result. > > > > When connecting a PX3 to a KX3 and there is no antenna, the flat signal on > the PX3 has some artifacts. The highest being where the KX3 unit is placed > and then 2 to 3 on each side symmetrically of decreasing amplitude. This > means that when you scroll the VFO for a signal it appears as if you are > always on a signal! > > Usinbg the same PX3 on another KX3 I get the same. > > > > Unless KX3 rigs are sensitive to some local noise (compared with a K3 where > there are no artifacts on a P3) then it may be the PX3 itself, but what is > the adjustment to cancel this? Any clues or suggestions would be appreciated. > > > > 73 > > Robin > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
