This was covered in a post on the reflector a couple days ago - a small padder capacitor from the junction of X3, X4 and C174 to ground may solve your BFO low frequency problem. Use 1 or 2 pf and recheck both ends of the BFO range after adding it.
Normally 4912.86 can be low enough except in extreme cases - note that the LSB BFO is set at 4913.7 which is well within your currently available BFO range. 73, Don W3FPR > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] Behalf Of [EMAIL PROTECTED] > Sent: Monday, July 03, 2006 1:30 PM > To: [email protected] > Subject: [Elecraft] Additional Info on Problem > > > On double checking the BFO Test (pg 62 of manual) the BFO Low > Freq. is too > high. The manual says it should be less than 4912.7 mine is > 4912.86. How can I > lower it? > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > Mime-Version: 1.0 > Content-Transfer-Encoding: 7bit > Content-Type: text/plain; charset=US-ASCII > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > > > -- > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.1.394 / Virus Database: 268.9.8/380 - Release Date: 6/30/2006 > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
