Interesting! This has begun just in the last few weeks.
Thx! Tom W4KX Sent from my iPad > On Jul 5, 2020, at 5:37 PM, Fred Jensen <[email protected]> wrote: > > I can't answer your question but when I still had my KPA500, I had that same > issue. Got in the habit of always checking the power setting before keying > when I put the amp into OPR. > > 73, > Fred ["Skip"] K6DGW > Sparks NV DM09dn > Washoe County > >> On 7/5/2020 2:07 PM, Tom Doligalski via Elecraft wrote: >> I have a relatively old K3, which I use together with a KPA500 and a KAT500. >> Most of the time this works flawlessly. >> >> However, occasionally the K3 gets confused and doesn’t realize that the >> KPA500 is in “Operate” mode (rather an in standby). This results in the K3 >> sending 100 watts to the amp, and the amp faults. >> >> Again, this doesn’t happen often, and I can’t ascertain why it occurs. Most >> of the time all is OK. >> >> The K3, KPA500 and the KAT500 all are running the latest firmware. >> >> Any idea? >> >> 73 >> >> Tom W4KX >> > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
