I am just getting around to building my K2 that I purchased in 2008.
I've been busy. But I'm having fun now!
I have the K2 Owner's Manual Revision G, May 29, 2007. I also have
Errata sheet Rev. G-1, Dec. 12, 2007.
In the Front Panel section, page 27, the original instruction advises to
use two spacers at each end when installing the LCD backlight diffuser
to keep the diffuser exactly 1/8" above the PC board. The Errata sheet
clarifies to use the spacers but remove them after soldering the
diffuser into place.
The issue is that the two spacers are 1/8" thick. The diffuser leads are
exactly 1/8" long. This means with the spacers in place, the diffuser
leads don't actually reach the solder holes. The lead ends are suspended
just above the holes. If I actually manage to line everything up and use
rubber bands to hold all in place while I solder (good luck!), the
solder would need to bridge up to the ends of the diffuser leads for the
soldered connections to hold. This doesn't seem like a good practice.
Is there a newer errata sheet? Or am I not understanding this correctly?
Murray
VA1CQ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
