Tom,
You might shoot an email to WX0V (his email is on QRZ). Since he 'wrote
the book' he might be able to help you the best. I know his Dad, W0ELM
quite well and he is a great guy so Scott must be too. BTW, I suspect
there may be a 7300 menu setting causing the problem.
73,
-de John NI0K
Tom Whiteside wrote on 7/21/2020 5:16 PM:
My early vintage K3 headed back to Elecraft for repairs this week and I'm
trying to get my ICOM IC-7300 to fully interface with the KPA1500. I have
followed the instructions Elecraft includes in the manual plus a great video
from WX0V - I can key the amp just fine but the amplifier is not tracking
band changes by the IC-7300. I have the stereo cable going between the
KPA-1500 XCVR Serial and the IC-7300 CI-V Remote control jack and the
KPA1500 key-in RCA plug connected to the IC-7300 send control jack.
On the KPA1500, I have the Serial Speed host set to 19200bps and the Serial
Speed XCVR also set to 19200. Not sure what the Serial Speed Host is for -
it is not mentioned in the instructions for the IC-7300. Radio Type is
ICOM. On the IC-7300, the CI-V USB baud rate is also set for 19200, CI-V
Transceive is on and the CI-V Output is on.
I have tried other baud rates. Anyone have any ideas? Thanks!
Tom N5TW
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
