Vin,
At 06:10 06-07-06 -0400, you wrote:
[Aligning a KX1]
So I took a metallic screwdriver and
electrical taped the entire shaft except for the tip. Despite the
insulation, the metal in influencing the alignment, of course, so I am
trying to align slightly, pull away and see what happens. If I touch the
board near the cap, the gains comes WAY, WAY up, but only for the duration
of the touch.
Yep, I noticed that to. I didn't have a plastic alignment tool, I ended up
slipping a scrap of paper over the screwdriver to isolate it. Surprisingly,
it worked.
Also, I notice that while listening to receive, I am hearing
signals, but not nearly as strong as I hear them on any other receiver in
the shack on the same antenna.
I did NOT notice that. If it still occurs even after you have the alignment
straight, I'd say something isn't right.
Best, Bart de PA3GYU
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
