I would suspect a Windoze update scrambled your sound assignments. Go
back and check all your settings.
k4ia, Buck
K3s# 11497
Honor Roll 8B DXCC
EasyWayHamBooks.com
On 8/23/2020 11:56 AM, N4ZR wrote:
Recently, I began trying to use the rear microphone jack on my K3 with
my Yamaha boom mike, instead of using a stand-alone USB sound card and
feeding the signal to the LIN IN jack. This worked fine for a couple of
weeks, but today when I tried it, I got very loud white noise driving my
radio and amp essentially to full scale. I have MIC SEL set to RPH BIAS,
which has worked in the past. Any MIC gain setting over 7 drives the amp
to full output. When I pull the mike plug out of the jack, the problem
goes away.
Have I inadvertently messed up another setting, or perhaps a failure in
the mike?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
