I have worked on thousands of these and I *never* pull the side panel to
take out the KAT3 (or KANT3) boards.
Too difficult if there is a sub-receiver and too likely to introduce a
problem (broken regulator(s), miss-pinned sub receiver) from removing
all that.
Take off top cover and take out top rear screw thru rear sheet metal
next to KAT/KANT3 board standoff.
Take out zinc bolt and split washer holding the KAT/KANT3 card.
Push the rear sheet metal back slightly and rock the card until it pops
up, then pull the antenna wire pin(s) out of the board and pull the rest
of the way out.
Keith WE6R Elecraft K3 Tech.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
