Hello Elecrafters,
I had a similar problem with a K3 this past March. My brother had his K3
die and I offered to look at it for him. He claimed that he could only
hear things on part of 80 meters. All the other bands were dead on RX
and TX. When I checked it, I found similar symptoms. At one point it
started working again normally, then, with the next power cycle, it died
again. The problem was traced to the synthezizer. Board layout
diagrams are a bit sketchy for troubleshooting. I contacted Customer
Support and a wondeful tech guy gave me some pointers on where to look.
The problem, while seeming to be serious, turned out to be a simple
fix. The 8 volt three terminal regulator mounted on the side panel had
rolled over and died. When I got everything running again, I made some
notes (complete with pictures and arrows ) I tried to attach it to my
response to N2RD and the reflector, but the e mail was rejected as it
was too big. I think the notes are pretty good as it shows where to look
for voltages involved with the synthesizer, as well as LO signal levels
and frequencies, on each band for the receive and transmit paths.
Is there a simple way I can post these notes so all can see it? I did
send them to N2RD to help him figure things out. If anyone is
interested, I can send them the note. It is a WORD document and is about
3.2MB in size. The size is due to color pictures of the circuit boards
showing the test points etc.
73
Dave K1WHS
On 10/7/2020 11:26 AM, Rajiv Dewan via Elecraft wrote:
My K3 (with all S upgrades, ser #170) stopped working over the weekend. I
noticed that on 80m, while the frequency on the rig was 3574, the frequency
reported by KAT500 was 3152 (or so). No output on any other band. I then
checked reception of WWV - no reception of the 10Mhz signal. I fed in a -50dBm
signal at 3574KHz. No reception.
I am going to crack the case on the weekend.
The only think I can think of is that something has shaken loose as the rig was
transported by car a while ago. Given the odd frequency, I am thinking that it
may in the LO chain.
Any thoughts?
Raj, N2RD
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
