Jack,
This fault has been reported several times and usually turns out to be a
problem in the KPA500 T/R switch area.
I suggest you consult with [email protected] for guidance on how to
proceed (fix it yourself or send it in for repair).
73,
Don W3FPR
On 10/15/2020 6:34 PM, [email protected] wrote:
All,
My KPA500 amp, (#2208 kit built), was acquired used but well cared for. It
has operated perfectly for several years until today. I was in QSO on 40M
when the amp threw a fault and the signal strength of received signals
dropped markedly. When I put the amp in standby, the signal strength of the
received signals returned to expected levels. I do get a TX power indication
appropriate to the drive level on keying up. This issue does not clear when
the power is cycled.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
