Carlos...
The numerical values associated with the K2 filter settings are
approximations, used mostly for reference when adjusting the filters.
They do not indicate the "exact" filter bandwidths, etc.
Aligning the K2 filters is best accomplished following the instructions
on Don Wihelm's site, http://www.w3fpr.com/. Look at the bottom of the
main page for "K2 Filter Alignment." Don is an expert authority on the
K2, and his instructions are just about the standard for aligning the
filters.
...robert KE2WY
On 10/20/2020 07:35 AM, carlos popelier wrote:
for the cw filter values in cw like fl2 0.70 is this 700hz?
and if you make a change to fl2 0.50 most one updating bf2 as well to
other values
carlos on6cn
--
Robert G Strickland, PhD ABPH - KE2WY
[email protected]
Syracuse, New York, USA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
