Carlos,
Do you have the internal frequency counter probe plugged into TP2? That
is one possible cause, remove it and retest. CW or SSB mode? All
spurious signals should be greater than 43 dB below the carrier level -
they cannot be expressed meaningfully in dBm, only with respect to the
carrier.
The binocular toroid is a transformer to match the impedance of the PA
collectors to 50 ohms, which is the input impedance of the Low Pass Filters.
73,
Don W3FPR
On 10/25/2020 7:40 AM, carlos popelier wrote:
hi, i see 2 spurious left and right from the 3,5mhz main carrier, output 10w,
on 2,1 mhz and 4,9 mhz -40 and -38 dbm with -30dbm attenuation
i wonder i anyone could tell me the correct level for the attenuation
and maybe why this signals are there, not so simple as i stated of
course,and what is the purpose of the binocular toroid in the power
amp section.
carlos on6cn
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
