Dan,
The Tek 453 has two vertical input channels. Did you connect to the one
that is being displayed? Are you using a 10X probe?
Yes, you should see a square wave if you have the vertical amplitude and
the horizontal sweep set correctly.
73,
Don W3FPR
On 11/7/2020 3:47 PM, Dan Presley wrote:
I have a question about the XG3 signal generator. I’m setting it up for some
troubleshooting and tracing on my K2 (issues with 160 module installation) and
I have a TEK 453 scope that I barely understand how to set up properly. I got
the unit from the TEK museum here in Portland,OR and it was completely
refurbished and calibrated by the guys there. The issue is that when I connect
the XG3 to the scope (just for observation and practice before I connect it to
the K2) it seems to be just outputting a straight line like a DC voltage.
Shouldn’t it be showing a waveform either square or sine? I tried connecting
it to an older scope just to check and same results. What am I missing? I’ve
played with the scope controls by it’s quite likely I’m missing something
obvious!
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
