Kent, yes and the KXPD3 is brand new just received from Elecraft,
which has the new wired paddle design.
I think that is ok, but I suspect a connection issue via J9 > pcb, or a
keyer fault.
Adrian Fewster
On 24/11/20 5:16 am, K9ZTV wrote:
Are you using the little Elecraft paddle attached to the rig? If so, there is
a known grounding issue in early paddles.
Kent K9ZTV
On Nov 22, 2020, at 11:16 PM, Adrian <[email protected]> wrote:
Kent yes i did try that. I prefer Iambic A as Petr does, his experience is
identical to mine.
I had tried iambic B previous to your advice with no change, and i don't use
squeeze keying in any case. this is testing at 15 wpm.
The issue is random, and sometimes I can nearly get through a CQ without it
messing up.
On my Yaesu rigs, same procedure, I have no issue and the send is perfect heard
& tested with cwget monitor.
On the KX3 I can tap for a dah and sometimes get a dit-dat-dit or dah-dit.
When sending the 4 in my call I often get a dit after the last dah.
or a dah-dit on the T.
How the right paddle can produce a dit is beyond me. Left is set dit.
I have played with weight and delay settings also to no avail. Thankyou for
your response.
73
Adrian Fewster
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
