On Wed, 12 Jul 2006 18:46:56 -0500 "Dr. Dan Swartling" <[EMAIL PROTECTED]> wrote: > I am half-way through building my K1 #2222 and have hit a stumbling > block. How are trimmer caps C13 and C20 installed? On the revision E > board it is not obvious (to me) which way to orient the flat side.
Cool serial number! I had the same problem. I looked them up in the parts placement drawing at the back of the assembly manual and here I could clearly see how they should be mounted. The flat side should face towards the back of the PCB. A rather bad picture, but this may help too: http://www.oz9aec.dk/pictures/gal/Homebrew/Elecraft_K1/K1-0048.jpg > > Dan 73 Alex OZ9AEC K1 #2172 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
