Raj, That certainly sounds like a Writelog problem. If the K2 works properly with another program, then there is nothing wrong with the K2 interface or your connections - that leaves only the driving software and a small chance that the sequence of commands is creating an unexpected path somewhere in the K2 firmware.
There are methods of polling that are known not to work properly for all combinations. As an example, the polling done by the N4PY rig control software causes problems if the KRC2ACC is incorporated into the setup - the N4PY software works FB without the KRC2ACC included, and works nicely with the KRC2 (only the 'ACC' versions gives problems). So far, Carl has not been willing to change his software to avoid the problem. 73, Don W3FPR > -----Original Message----- > > I tried to use my K2/KIO2/XV combination with Writelog for last > weekend's CQWW VHF competition and failed. > > I hooked up the K2 to a serial port and set it up on Writelog. While > Writelog recognized the rig and could set the frequency, it went > crazy while polling the rig for frequency. It would keep cycling > through all the bands and show random frequency that seemed to change > with each poll. > > (BTW, the combination worked just fine with N1MM logger.) > > Has any one else noticed this? Any fix? > > Thanks, > Raj > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
