Bill,
What radio? Is the RF gain cal. OK (assuming a K3)?
What is the SWR on the radio into the dummy load without trying to do
the calibration, I.E. direct? Don't know for sure that is what you meant.
You can try to do it manually, just on the 10 Mhz band. Then run the
whole thing to see if it works, if you want.
Carl
AB1DD
Resistance is futile.
(don't know about reactance, though)
On 1/28/2021 10:50 AM, Bill Steffey NY9H wrote:
i am very rarely on 10 mHz,
while running tx gain set , the calibration fails at 10mhz due to
SWR 3.3-1 TOO HIGH FOR CALIBRATION.
checking other bands..160- 6 all read low swr
lp-100 & WATERS swr/load read low swr ..... hi swr just reads on
radio & faults the tx gain procedure ????
ideas ???
bill
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
