I found it !!! For a reason that I cannot explain.... I put earlier on
the control board a jumper over FUNC on P1 header.... and should not be
there. Now, everything works fine. With my Kenwood MC-43 mic... no
problem... but with Yasesu mic, it was affected by this jumper. Anyway,
no extra function is available when using this jumper.
73
JEAN-FRANCOIS MENARD a écrit :
Hi,
I very confused, I'm trying to connect my Yaesu MD-200A8X mic to my
K2. I changed all wiring of the Yaesu mic to match my other Kenwood
mic. I don't want to change jumper block on the control panel... and
the Yaesu mic will be used exclusively on my K2 now.... but for
outdoor operation, I will use the Kenwood hand mic... so this is why I
changed the Yaesu mic connector to match my Kenwood mic connector.
If I push UP or DOWN... OK VFO A or B selected...... When I push
PTT.... it transmit.... but when I release the PTT button.... freq.
change to VFO A or vice-versa...
Any idea what I have done wrong.. ??!?!?!?
Thanks
J-F VA2VYZ
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com _______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
