I am running an Elecraft K3 and a KPA1500 amplifier. I use the DXLab
Suite of programs for logging, rig control and so on.
If I do a manual band change on either the K3 or using the KPA1500 and
change back and forth between 15m and 40m, the side band changes
appropriately.
If I do it using the Commander Bandspread window buttons and go from 15
to 40, it stays in USB. I can then do a MODE ALT to get the correct
mode, but it doesn't stick if I go back and forth.
FWIW, going to 80 has the same issue...
I suspect the K3/KPA1500 set are working correctly since the only
misbehavior is when I do it with Commander.
Has anyone else seen this, fixed it, or have any hints?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
