I resoldered the LED backlight devices by applying a small amount of pressure and resoldering each pin to make sure they were flush. This made the pins of the LCD flush with the PCB holes. I soldered it this way and it has worked. The LCD is working fine for my K2.
Bruce, WB6IZG On Sat, Apr 10, 2021 at 6:05 AM Phil Le-Brun <[email protected]> wrote: > Bruce, I am having the same issue. The LEDs are flush to the board, the > plastic overlay installed but then the LCD sits to high to get the pins > through > > Phil, G0HHN > > > > -- > Sent from: http://elecraft.365791.n2.nabble.com/ > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
