If you have any of the remaining screws then take one to the hardware store when you go. They will do a perfect match for you. They use an aluminum template folds referred to as a Screw Checker to make sure it is correct. The sis not an “eyeball exercise.” There is nothing about that screw usage that is demanding in terms of material science, etc.
Regards -Hal WB6NNR (I was a design engineer for 35 years….You will be fine) > On Apr 13, 2021, at 9:36 AM, Tommy Judson via Elecraft > <[email protected]> wrote: > > Make a bad purchase good? > Bought a KX-2 off the internet and have found that it is missing several of > the screws that held the end plates on. Asked about that and the seller said > he tried to put some sort of protective end plates onto the radio but > couldn’t do it so threw them away and put the original end plates back on. > What concerns me about just going to the hardware store and getting more > screws (that might not be the proper thread/length) is I think two of the > screws held the final output transistors onto that end plate which I assume > was for that end plate to act as a heatsink. > The seller said he used the radio and it seemed to be ok but I am concerned > about the lack of heatsink/output transistor integrity and any possible > damage. > Maybe I’m on the wrong track here because of never seeing a KX-2 before. > The radio looks good - no scratches or dings and the seller told me to find > out what is needed to be done to fix it and he’d send that to me. > Any help on this concern would be appreciated. > F.Y.I - the serial number is 03742 and the Firmware is REF5. Sure would like > to know when this radio was made and if this is the latest firmware. > 73, Tommy, N5CTC > >> On Apr 12, 2021, at 9:38 AM, [email protected] wrote: >> >> Send Elecraft mailing list submissions to >> [email protected] >> _______________________________________________ > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
