Resending this as I have not received any replies yet. Could anyone possibly help me out?
Thanks! Darrell ---------- Forwarded Message ---------- Subject: KAT100-1 Measurements? Date: July 6, 2006 03:52 pm From: Darrell Bellerive <[EMAIL PROTECTED]> To: [email protected] Would someone be so kind as to take some measurements of the KAT100-1 Antenna Tuner: The horizontal distance between the center of the Antenna 1 SO239 connector (J5) and the center of the Antenna 2 SO239 connector (J6). The horizontal distance, parallel to the back panel, from the center of the Antenna 2 SO239 connector (J6) to a projection of the outer edge of the left side panel. In other words, how far in is the center of the Antenna 2 SO239 connector from the outside edge of the left side panel? The horizontal distance, parallel to the back panel, between the center of the Antenna 1 SO239 connector (J5) and the vertical center line of the ground screw (E1). I am building a new feed-through panel and want to make it line up properly with a KAT-100-1 which I have not yet purchased. There will be short runs (2 inches or so) of coax between the feed-through panel and the tuner, so the measurements don't have to be exact. The coax will compensate for a slight offset. Thanks in advance! Darrell VA7TO K2#5093 ------------------------------------------------------- -- Darrell Bellerive Amateur Radio Stations VA7TO and VE7CLA Grand Forks, British Columbia, Canada _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
