Config -> LIN OUT -> tap REV/2 button. Use VFO A knob to adjust t= xxx to set transmit monitor level. 0 = none and up from there. Mine are set at 010. YMMV.
Ken K6MR From: HP<mailto:[email protected]> Sent: Wednesday, April 28, 2021 23:36 To: [email protected]<mailto:[email protected]> Subject: [Elecraft] Record both RX signal and TX monitor in CW Using AUDACITY and the K3S USB Audio Codec -recording received signals works fine-but is there a way to also record the TX monitor signal ? Obviously I can run another computer running Audacity and simply record the speaker or headphone output bit is there any way to avoid that ? Hank K7HP ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
