I have two K3 questions:
1. In Data MD, AFSk A, you can set the baud rate to either 45 or 75.
Is the baud rate just for the RTTY reader? Does it affect anything else?
2. With my K3s power set to 100w, RTTY starts at a little below 50w
and and then fairly slowly builds to 100w (measured on an external
wattmeter). I've done a TX calibration -- no change. What is going on?
Thanks,
- 73, John, N0TA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
