My ESD concerns started when I had completed my K2. There were occasions upon
turning on my K2 that my finger approaching the VFO knob would cause my K2 to
lock up. (BTW, the rig was well grounded.) As it turns out, it was my finger
approaching the mike connector that caused the problem. I suspended two small
springs between the two mike connector mounting screws to ground the floating
mike connector and eliminate the ESD. ESD is very real for sure! Thank
goodness, grounding the mike connector cured this problem. Roy Morris W4WFB
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.394 / Virus Database: 268.10.4/396 - Release Date: 7/24/2006
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
