With a KPA500, just set RADIO to K3, and this works fine with the K4. No KPA500 firmware update is needed.
The K4 recognizes the difference between the KPA1500 and KPA500 by the AUXBUS messages it receives, so it changes popup messages such as "KPA500 Status: operate" and "KPA500 Status: standby" to "KPA1500 Status: ..." automatically. 73, Bob, N6TV On Fri, Apr 30, 2021, 3:50 PM Alan - G4GNX <[email protected]> wrote: > Is there an update to the KPA500 firmware that reflects the K4? > > 73, > > Alan. G4GNX > > > ------ Original Message ------ > From: "Bob Wilson, N6TV" <[email protected]> > To: "James F. Boehner, MD" <[email protected]> > Cc: "Elecraft Reflector" <[email protected]> > Sent: 30/04/2021 05:38:24 > Subject: Re: [Elecraft] K4 interface to KPA-1500 > > >Also be sure to set RADIO TYPE to K4 in the KPA1500 menu. If you don't see > >it listed, upgrade the KPA1500 firmware. > > > >73, > >Bob, N6TV > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
