The lack of output power on both 10 and 12 meters suggests a problem in either the lowpass filter (post-PA) or bandpass filter (pre-low power PA), which in both instances is common to those two bands. I would check relay activations on the input and output sides of both the BPF and LPF 10/12 meter filter sections to be sure that those filters are being selected.
You should try to listen on 10 and 12 meters if you have an external signal source (signal generator or another transmitter into a dummy load with a length of wire for a RX antenna near the dummy load) for those bands - are you able to hear a test signal? And the most obvious suggestion, which I would check first: do you have the proper antenna port selected on the front panel? (ANT 1 or ANT 2) The antenna port selection is band-specific. Presumably, the proper antenna port was selected for the dummy load test you ran? 73, Mike, K8CN -- Sent from: http://elecraft.365791.n2.nabble.com/ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
