Greetings,
Someone beat me to this, but here's the official word...release 22 is now
available as beta on our software downloads page. Upgrading is recommended in
order to remain current.
Release notes are listed below. They can also be found on our website, as well
as directly at the radio itself in the update utility.
73,
Wayne
N6KR
====================
==== RELEASE 22 ====
====================
BUILT-IN OPERATING MANUAL UPDATED: Now at rev. C9. Among other changes,
includes important note about Bose QC35 and similar headphones that are
capacitively coupled. These will work with the rear-panel phones jack as-is,
but for use with the front panel jack, a resistor to ground from the tip signal
is needed to provide headphone insert detection.
SCREEN CAPTURE IMPROVEMENT: There is no longer any need to remove and reinsert
the USB flash drive after every screen shot.
TX EQ NOT APPLIED IN DATA MODES.
FSK/PSK MONITOR LEVEL ADJUSTABLE: FSK/PSK monitor level is now equal to the
DATA monitor level, not by the CW sidetone level. It can be set separately by
holding {XMTR}.MON.
FSK/PSK MONITOR LEVEL VIA PADDLE VS. FSK IN: When FSK/PSK characters are sent
using the keyer paddle, the FSK/PSK monitor tones will be 12 dB below the CW
sidetone volume, as before. But when FSK/PSK transmit is initiated via XMIT,
PTT, or a KY command, the monitor volume will be set based on the DATA monitor
level (cf.dataMonLevel).
VFO CURSORS TUNE SMOOTHLY ON PANADAPTER: Some users had observed jitter in the
panadapter cursors while tuning the VFO.
TRANSVERTER BANDS > 2.1 GHz BEHAVE CORRECTLY AT PANADAPTER: Previously, use of
transverter band frequencies above 2.147 GHz would cause the panadapter to
freeze.
ADC OVERFLOW FALSE TRIGGERING ELIMINATED: Previously, changing preamp or
attenuator settings could cause a spurious ADC overflow indication ("OVF" icon
at the right end of the S-meter).
PRE3 SETTING PRESERVED ACROSS POWER CYCLES.
BUILT-IN OPERATING MANUAL IMAGES CORRECTED: All figures are now correctly
formatted, including the illustration of the RX Dynamic Range icon (see
Advanced Receive Features section).
USB FLASH DRIVES WITHOUT OPERATING SYSTEM PARTITIONS: These are now handled
correctly.
DURING SOFTWARE UPDATE, EXT. MONITOR MIRRORS LCD.
FOR SOFTWARE DEVELOPERS: Switch emulation codes (SW command) now have permanent
fixed values, per rev. B12 or later of the K4 Programmer's Reference.
Previously, these codes were inadvertently changed as new switch functions were
added.
SOFTWARE UPDATER SHOWS RELEASE PACKAGE NUMBERS: When the user selects an
installation type, the associated "Rnn" release numbers appear beside each type
(production, beta, etc.).
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
