KPA3 circuit breaker?
Regards,
Mike VP8NO
On 11/09/2021 10:13, David Sumner wrote:
Lee, it may not be that bad. Check Config to make sure KPA3 shows “PA nor” —
there are other causes of your symptom as well that others may be able to
comment on. 73, Dave K1ZZ
Sent from my iPhone
On Sep 11, 2021, at 8:35 AM, Lee <[email protected]> wrote:
If I had to guess, I would say the finals are blown in my KPA3.
If I advance the power knob, output is normal up to 12 watts. As soon as
the power is advanced to 13 watts, the power drops to near 0, perhaps 1/4
watt.
Any help on troubleshooting?
Assuming the finals are blown, is it possible to just return the KPA3 to
Elecraft for repair, rather than the K3 itself?
Thanks for any help! Lee
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
