Jerry ...

In either of the failures, were you controlling transceiver output through ALC 
or, as it sounds, manually?

73,

Kent  K9ZTV


> On Sep 18, 2021, at 8:48 PM, Jerry Kirshenbaum <[email protected]> wrote:
> 
> re: it'd pay to review the SPE
> 
> In May 2021 I bought a SPE 1.5K-FA 2nd generator new from the distributor in 
> Texas. I’ve been using a SunSDR2 DX 100W transceiver while I wait to receive 
> my K4D. The 1st time the finals blew may have been operator error. 
> Subsequently, I discovered that the software allows one to limit the power on 
> each band. So I set the SPE to mid power (it has low, mid, high settings) and 
> determined the correct output for 700-800W. That left at least 20% head room. 
>  Despite this seem lying failsafe procedure, the finals blew again. The 
> distributor would not cover this under warranty on the grounds that my radio 
> has spurious spikes which blew the finals. In fact, if you run the “wrong” 
> radio with this amp, you don’t have any warranty because the radio is 
> indicted as the cause of failure sight unseen.
> 
> The amp when it works is wonderful. One case, 24 lbs, very quiet. I had 
> everything linked together with my SteppIR DB18E through DxLab. 
> 
> Two times back to the distributor for repair in 3 months was enough. I sold 
> it and now have a KPA1500 which is working great.
> 
> BTW, the distributor also says the IC-7300 (my backup) has spurious spikes as 
> well and presumably is another transceiver not covered under their warranty.
> 
> 73, Jerry / K0ES
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to [email protected]

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected] 

Reply via email to