Yes, Windows 10 is wonderful at keeping our blood pressure up. On Sun, Nov 14, 2021 at 12:14 PM Mike Dodd <[email protected]> wrote:
> It's all working now, and I can't explain why. > > Rich VE3KI sent me a suggestion off-list to try the Windows 10 Sound > Control Panel. > > The ONLY thing I did there was select the USB CODEC, check that the > playback level was not 0, and click the Test Device button. That > produced a few tones, and the K3 produced 100W into a dummy load in the > DATA mode, just as it should. > > I launched N1MM with the Digital window open, and pressing F4 sent my > call, and the K3 again produced RF. > > So I switched back to the Carolina Windom antenna and worked LA1TV on > 15M with the KPA500 pumping out 300W. > > Bottom line: The K3 was not producing RF in DATA mode when I started > this morning, then produced RF after I tested the USB CODEC in Sound > Control Panel. I have no clue why. > > Thanks again to everyone who offered advice. > > --- > 73, Mike N4CF > Louisa County, VA USA > Elecraft K3s / P3 / KPA500 / KAT500 > Carolina Windom up 45' > http://n4cf.mdodd.com > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > -- Jim K0XU [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
