A classic problem. You have TOO MUCH input gain. Counterintuitively the KX 3 ALC will display nothing if over driven. Turn the input way down and then increase in small steps. You will find the right setting to show ALC that way. On Tue, Nov 23, 2021, at 2:57 PM, Frank O'Donnell wrote: > After not having used my KX3 in a while, today I set it up with a laptop > on the front porch to send FT8 in WSJT-X with a new AX1 antenna. > > I went through the procedure in Don W3FPR's document "Setting Elecraft > Transceivers for soundcard digital," setting in and out audio levels on > my MacBook Pro for the thumbnail-sized Sabrent USB soundcard; Mic Gain > on the KX3; and the power slider in WSJT-X. CAT control is working fine, > and the KX3 is in DATA A mode. The waterfall of incoming signals appears > normal. > > I seem to be getting a good signal out, with -1 dB reported from Alaska, > and -7 to -10 dB from the U.S. east coast with the above settings around > midrange, and with the KX3 set for 15w out. However, I don't see any > bars at all on the ALC meter at any time, even when the USB soundcard > out, KX3 Mic Gain and WSJT-X power slider are set as high as their maximums. > > Am I forgetting a setting? Anything I can look at to troubleshoot the > ALC meter function? > > Thanks much, > > Frank K6FOD > Southern California > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
