Was operating remote in CQWW using a K3 and RCforB.? I was unable to
adjust the sidetone volume, which I found too loud.? The host is using
Line Out to connect to the sound card, which provides a fixed audio
level.? is there a way to independently adjust the sidetone level via
Line out?
Respectfully adding to Pete's response: "sidetone level on line out" to
me means the amount of audio on the line out output while you are
transmitting, to "monitor" your own transmissions.
If this is what you are after, there is ab obscure description in the
release notes of the K3 5.88 firmware description:
TX LINE OUT (MONITOR) LEVEL NOW ADJUSTABLE:
In CONFIG:LIN OUT menu entry, tap '2' (REV switch) to set the "T="
level (TX monitor). Tap '2' again to return to the RX LINE OUT setting.
Hope this helps,
Geert Jan
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
