Mike K8CN wrote
*< It wouldn't have occurred to me to look atthe LPA stage as a source of trouble, but ifthe TX power is ramping up slowly, then I cansee where the ATU control algorithm isconfused by the change in power levels bothforward and reflected. My ATU seems tochange relay settings very fast, and the controlalgorithm is looking at change direction (maybechange magnitude as well) in SWR to decidewhich relays to flip next. The relative adaptationspeed of the control algorithm and the TX powerramp-up could certainly cause interactions thatmight slow the ATU convergence, but I wouldthink that once the TX output power stabilized,the ATU control algorithm would be receivingvalid SWR readings as it flips relays.When you say it takes seconds to ramp upto full (TUNE) output power, does this happenon every TUNE button press? Does it also occurwhen you send CW from the paddle/key? Canyou watch the RF envelope on a scope to timethe power ramp-up?73,Mike, K8CN >* Mike, Thanks for that and I do understand what you say about the possibilty of the control algorithm getting confused by the slow ramp up of power. Last week Rob at Elecraft Support had me using a 50 ohm dummy load with the KAT3 bypassed. Set PWR to 5.0 W and hold down XMIT to TUNE, this performs a Tx gain calibration. Then set to 11.9 W and TUNE again. My results were 5W immediately but rising from 8.4 to 9.8 W in about 6 seconds Rob then had me checking WMTR LP setting in CONFIG menu (TECH MD ON). This was set to the default value of 70 which he suggested I increase . (I'm not at all sure what this is doing). Increasing this value to the maximum of 180 gave me 10 W increasing to 12.0 W in 2 seconds, faster but still quite a delay. This does happen on every TUNE button press but I don't have any problem during my daily use of the rig on CW. I have not fired up my old Tektronix scope yet to look at the keying envelope. Elecraft Support have gone quiet this week so no further progress. 73 and thanks for your help, Tom G3OLB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
