Lucky your that close! My K3, P:, Lp100 and kpa1500 are all wayyyy different. I accept the LPA100 as being correct!
Ron W5SUM Sent from my iPhone > On Feb 5, 2022, at 2:11 PM, Dick Dievendorff <[email protected]> wrote: > > If you turn in the Tech Mode menu item, there is a WMTR ADJUST menu item > that might be easier to use than the command tester commands. > > 73 de Dick, K6KR > >> On Feb 5, 2022, at 10:33, N2TK via Elecraft <[email protected]> wrote: >> >> If I measure the power out on my K3 (set to 100W), P3, LP-100 and KPA1500 >> (power on but in standby), they all read quite close on 10-160M into a dummy >> load. On 6M the P3 reads 16% higher than the other three. If I use 20W drive >> from the K3 and put the KPA1500 in operate mode, the P3 and LP-100 read >> quite close into a dummy load. But the KPA1500 reads about 6-11% higher on >> 6-160M.The readings are close enough not to be concerned. Looking at the >> KPA1500 manual there are commands to adjust the wattmeter readouts by band. >> I tried commands in the KPA1500 utility Command Tester (^RV;) as an example, >> but nothing happened. Checked the Port tab to make sure the utility is >> connected to the amp.What am I doing wrong? Can you do what I am trying tp >> do from the Command Tester.TnxN2TK, Tony >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
