My old cable, used with K3 and KPA500 works fine with K4 to KPA 1500 except the K4 receive is shut down when 1500 in off, regardless of cable or use of interruptor. Ideas?
Happens Only on 40 and 75, not 20. No receive until 1500 is on. I also tried the new cable. Bob K7VO On Tue, Feb 22, 2022, 5:27 AM Dave <[email protected]> wrote: > No difference between using the K3 and K4. I use the same interconnection > cable that I used for the K3. > > The K4 shows the power level against the power control knob as appropriate > when you go from standby to operate. > > Power setting/control with the K4 and KPA500 is well controlled. > > 73 Dave > K4D #286 > KPA500 > -- > Sent from my iPhone SE > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
