Trevor, In the world of resistance, there is no such thing as 'no reading' - a very high resistance can be considered infinite while anything lower than infinity has a valid value.
You meter has a high resistance limit, and that will vary with whatever meter you are using. Look at what your meter indicates with the leads open and that will tell you how you should interpret those very high resistances. The KAT100 manual indicates that the points you mentioned should have a resistance of greater than 100k ohms (>100k), and that could be anything above 100k, even if that is the infinite resistance of an open circuit. 73, Don W3FPR > -----Original Message----- > > Have just been doing the resistance checks on a KAT100. > Everything appears ok except > for U2 pins 3, 12 & 13 where I get no reading whatsoever. > > I'm assuming that static has probably killed either U2, U3 or U4 > or perhaps all three - or is > there something else I should be looking at first. > > Any advise appreciated. > > Regards to all > Trevor G0KTN > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
