The KXUSB cable from back of Flex to amp is best method to have amp (and amp internal tuner) track radio frequency and band.
For control of amp, plug the amp Into your network (Ethernet port) then run the KPA1500 Remote app for normal operation. You can run the KPA1500 Utility via network for any configuration. Note - only one of the two apps can run at one time, so use the utility to configure amp them Remote app for control and monitoring. Works very well. 73 Dave wo2x Sent from my iPad > On Jun 21, 2022, at 5:30 AM, Ray Spreadbury via Elecraft > <[email protected]> wrote: > > I am just getting a Flex6600 to replace my Elecraft transceiver and intend > connecting the Flex radio to the amp using an Elecraft KXUSB cable ie. FTDI > USB to Serial, which I believe is the recommended method for auto band > switching of the KPA1500. > Is there software available for controlling the KPA1500 on my Windows PC as I > would like to locate the amp below my operating desk? I suspect I can do this > using the KPA1500 Utility program but wondered if there is a better method or > 3rd party software for this purpose? > 73 > Ray G3XLG > > Sent from Mail for Windows > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
