Morning...
Sounds like a job for an Arduino or PIC Micro, to interface between
radio and ATU, and possibly with additional indicators/buttons etc...
ATU on one side (two I/O lines from the sound of things, with maybe some
voltage level changing) and radio CAT interface on the other on a serial
port (or whatever a K2/K3 or ??? needs.)
That is the sort of project where you may find someone else has already
done something similar for other needs, so part way there, that you can
adapt and build on. (Google is your friend of course.)
Best of all, the needed development software is freely available (for
zero cost) and the hardware is low cost too. Plus... LOTS of tutorials
on-line to point you in the right direction...
From the below, it sounds like the needed event sequencing is already
known too, that helps enormously.
A nice winter project...
73.
Dave G8kBV
On 13/09/2022 20:03, [email protected] wrote:
On 04/09/2022 09:37,[email protected] wrote:
I looked up the Owner's Manual for the Z100A and it does not have
a "Molex" connector on the tuner. The radio interface cable is a
miniDIN6. The manual also does not list a cable for K3 (or any
Elecraft transceiver) - only the "IC106" cable for connecting power.
The DIN connector has 4 active pins it seems - plus and minus power, a
signal that should trigger the transceiver if you press the tune button
to trigger the radio to make RF, and a signal that indicates the tuning
process is complete.
None of the indication signals directly interface with the K3.
As others already said, I don't think the K3 has an interface for either
of these signals. The procedure would then be:
1. reduce output power on K3
2. press TUNE on K2 to start generating RF
3. Press TUNE on tuner to make it start a tune cycle
4. Tuner will indicate completion of cycle
5. Press TUNE to stop K2 generating power.
6. Restore RF power setting.
There is no integration between the K3 and the Z100A unfortunately.
LDG makes many tuner models, some actually talk to the radio to do part
of the above process automatically.
My suggestion is to join the LDG group at
https://groups.io/g/ldgelectronics
73, Geert Jan PE1HZG
--
Created on and sent from a Unix like PC running and using free and open source
software:
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
