I had a similar problem (not no signals, just no pronounced peak) when I was trying to use an antenna through a balun. When I removed the balun the issue was resolved. The peaks were much more pronounced.
David, k3tue . --- Soaring Eagles <[EMAIL PROTECTED]> wrote: > Hi Folks! > > I build KX1 sn/1519 and it worked great! I finished building up the KXB3080 > and installed it last night. All the tests were fine as I went along in the > build. However, when I try to peak the receiver, I'm not getting any > signals. I don't have an XG1 or 2, although I might need one! <grin> Also, > it doesn't make any difference where I set the RF Gain control, and I'm > thinking that's significant. I've looked for the obvious shorts and > incorrectly installed parts but can't find any. > > I'd appreciate any help. I usually get just the digest, so if you want to > respond direct, please do so. > > Thanks a lot!!! > > Jim Ujcik, WD9HBC > [EMAIL PROTECTED] > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
