Hi Hal
I see the Rds difference. Wouldn't the higher Rds be compensated by the better
Rth (thermal resistance from junction to case) spec in the ART devices?
73, Mike, W3IP
On Tuesday, November 1, 2022 at 03:15:09 PM EDT, Dynolab
<[email protected]> wrote:
While the higher voltage ratings of the ART1K6 or ART2K0 series looks very
attractive, it is extremely important to remember that heat is the number
one killer of LDMOS RF power FETs!
That being said, take a look at the specifications of the ART1K6 and ART2K0
and note that the Rds(on) drain-source on-state resistance of these devices
is significantly higher than that of the devices presently being used in the
KPA1500.
And this higher Rds(on) would result in higher drain-source saturation
voltage when the amplifier is running near its limits which would in turn
result in higher heat dissipation.
It is therefore possible that the ART1K6 or ART2K0 devices may be less
reliable than the devices currently being used in the KPA1500.
73,
Hal
W7YNC
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of M Cresap via Elecraft
Sent: Tuesday, November 01, 2022 10:21 AM
To: [email protected]
Subject: [Elecraft] KPA1500 replacement devices
Anyone have an educated guess whether the ART1K6xx or ART2K0xx devices would
be a drop in replacement for the currently used device in the KPA1500? Most
of the interesting specs are within 10% of the current device, the open loop
gain may be a dB or two higher (if the data sheets are really comparing
apples to apples).
The main attraction of the ART1K6 and ART2K0 devices is the higher peak
voltage handling capability - 177 or 200 volts vice 135 volts for the
current device. Maybe a higher peak voltage capability will keep the
amplifier out of the repair shop due to external events like arcing baluns
or antennas flexing in the wind.
The package styles are identical, the ART devices are in stock from a few of
your favorite distributors, similar price to the current device, maybe the
quiescent bias voltage would have to be tweaked a bit...
73, Mike, W3IP
-
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
