Beware of VGA cables and the K2, most [maybe all] are not
straight-through. The connector on the K2 has 2 pins approximating
RS-232 signal levels and 1 ground. The remainder are internal signals
at internal voltages.
Running solid state amps at seriously reduced drive levels can reduce
their linearity and increase unwanted signal products. Don't know about
the KPA1500 but might be wise to check.
73,
Fred ["Skip"] K6DGW
Sparks NV DM09dn
Washoe County
Eric Norris wrote on 1/11/2023 11:25 PM:
DO NOT CONNECT THE K2 SERIAL OUTPUT TO ANYTHING WITHOUT A CUSTOM CABLE OR
AN N6TV SERIAL BOX.
I got about 250w out of the KPA1500 with my K2/10, and of course full-tilt
disco boogie with my K2/100.
73 Eric WD6DBM
On Wed, Jan 11, 2023, 4:03 PM Karin Johnson<[email protected]>
wrote:
Hello Group:
Can I use a Elecraft KPA1500 with a Elecraft K2???
What accessory cable will I require????
Karin Anne Johnson K3UU
Palm Harbor, Florida
--
This email has been checked for viruses by AVG antivirus software.
www.avg.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
