I continue to be baffled by my K60XV problem. I have replaced R1 and
C12. I continue to get a short (zero ohms) between pins 13 and 14 on
U1. I thought I found a problem on the RF board: the coax shield may
have shorted the lead from P1 lead 7 to ground...I insulated the coax
shield exposed with tape. My thought was to recommend that shrink
tubing be used over the exposed shield on this side of the
coax...similar to that used on the other side of the coax to the RF
board. However, I still get the short between pins 13 and 14 of U1
on the K60XV without plugging it into the K2.
Can this be explained by a defective Z1? Any other ideas? Let's
face it, there aren't too many components on this small board! It's
very frustrating.
John
AB8O
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
